heating engineer Birmingham

This section is empty.

About Electric Boilers -

Central Heating

Power Flush

Could Be

The Answer To

Your Heating

System Problems!


A Central Heating Power Flush has a few different names such as Power Flushing, Jet Flushing and Hard Flushing it is a procedure that cleanses your heating system and boiler with high pressure, low velocity water and clears debris and corrosion. Cleansing chemicals are added to make it even more effective.

 

When air is in the heating system, it corrodes the heating system internally producing iron oxide sludge deposits in radiators and other important iron components. The sludge sticks to all surfaces and causes premature failure of pumps, valves radiators, boiler heat exchangers and hot water heating coils. Which reduces overall efficiency and wastes costly fuel?

 

The Central Heating power flushing will cleanse the pipes, pump, boiler and all the components in a heating system which have over time built up damaging sludge and debris. Statistics show that many malfunctioning boilers are replaced unnecessarily and would have been better off having a power flush performed.

 

Warning - Corrosion with in Central Heating systems accounts for up to 90% of all system and boiler failures.

If your boiler is making a noise like a boiling kettle, it is imperative that you call a heating engineer as soon as possible, a Hard Flush maybe an inexpensive remedy, as the boiler's heat exchanger could be getting jammed from the debris, and could well fracture leading to expensive repair costs or even a whole new boiler. Further, modern boilers are particularly susceptible to this as they are more compact than there elder relatives and debris can block the smaller components and pipe work.

 

Due to the economic conditions we live in, more and more people are putting their heating way down on the priorities list. Jet flushes can reduce your bills and increase the efficiency of a boiler and heating system by up to 35%. In fact, before a problematic heating system has been power flushed, it could be wasting up to a third of energy. So if you keep a well maintained heating engineer Birmingham system it will in fact save you a lot of money now and in the future.

 

Whether it is because a gas supply is not available, or simply that the home owner prefers using electricity, electric boilers as opposed to the gas variety are available to provide the home with central heating and hot water. In the not so distant past electric heating systems were restricted to blown air systems or storage heaters which were not energy efficient because they burned electricity when it was not necessary. But modern electric boilers have revolutionised central heating and the heating of water making them much more economical to use than was previously the case.

 

The reasons why power flushing is necessary

Firstly, power flushing method makes a boiler work faster and more efficiently, thus saving you time and money. Aside from sludge build up, dirty water in the central heating boiler also reduces the effectiveness of your boiler. According to recent tests, it was determined that dirty water actually reduces or compromises the longevity of your central heating boiler. The tests also compared flushed boilers to with non-flushed boilers and this revealed replacement boilers that where flushed showed an overall 6 % increase in the efficiency of the boiler.

 

If you think that simply replacing an old boiler maker would solve the problem, you better think about it again. Even before installing a brand new central heating boiler, power flushing needs to take place. It is important to do this to avoid any complications or potential problems in the future.

 

The Central Heating power flushing will cleanse the pipes, pump, boiler and all the components in a heating system which have over time built up damaging sludge and debris. So if you keep a well maintained heating engineer Birmingham system it will in fact save you a lot of money now and in the future.